Thursday, July 13, 2017

Up & Away



You could stamp some clouds from the Lift Me Up Stamp Set, or you could use the new Embossing Paste and Cloud Decorative Mask to make some nice fluffy clouds.  

When I cut out my large hot air balloon a Multipurpose Adhesive Sheet was used to make it easy to adhere my shape.  To use them you just cut your sheet the same size as the paper you will be using to cut out your die, peel one layer and place it onto the back side of the design you want to show (if using Designer Series Paper) and run your die through your Big Shot.  When the design is cut peel off the back of the sheet and your piece will be ready to place onto your project.  

To make my clouds blue I added a few drops of Soft Sky Ink to my embossing paste and then let the clouds dry for a few minutes before putting the card together.  

The following were used:

No comments: